Mazda 6 Quiz
Body electrical system

Inboard combination light removal/installation

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Disconnect the negative battery cable.

2. Remove the trunk lid trim (liftgate lower trim). (See TRUNK LID TRIM REMOVAL/INSTALLATION) (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.



4. Install in the reverse order of removal.

Inboard Combination Light Installation Note

1. Insert the inboard combination light into the trunk lid (liftgate) as shown in the figure, then pivot it inward and fix in place.


2. Pleace the bracket in the proper position as shown in the figure and press it to the trunk lid (liftgate) to attach.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.