Mazda 6 Quiz
Body electrical system

Steering angle sensor inspection

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
With DSC

1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)

2. Disconnect the steering angle sensor connector.

3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor.

4. Turn the steering wheel to the right and left, and verify that the voltage and pulses at the terminals are as shown in the figure.

  • If not as specified, replace the body of the combination switch.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.