Mazda 6 Quiz
Body electrical system

Headlight zeroset

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Note
  • When the configuration is not set for the auto leveling control unit, headlight zeroset cannot be executed.

1. Adjust the tire air pressure to the specification.

2. Position the unloaded vehicle on a flat, level surface.

3. Connect the SST (WDS or equivalent) to the DLC-2.

4. Turn the ignition switch to ON position.

5. Turn on the headlights (low-beam).

6. Input the vehicle information following the directions on the screen.

7. Confirm that the WDS or equivalent identifies the vehicle, and select Datelogger.

8. After the screen appears, select LHID under Modules from the cascading menu.

9. After the next screen appears, select CALAXLSN#.

10. On the graphic display that appears, press the icon near the top right of the screen indicated by a 1 in the figure.


11. After the next screen appears, press the icon indicated by a 2 in the figure.


12. After pressing the icon indicated by the 2, press the icon indicated by a 3 or 4 in the figure to execute the zeroset setting.

Note
  • Pressing an icon indicated by 3 or 4 once will execute the headlight zeroset setting.

13. After executing the headlight zeroset setting, perform an on-board diagnostic test and verify that no DTCs are displayed.

14. Perform the headlight aiming adjustment. (See HEADLIGHT AIMING)

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.