Mazda 6 Quiz
Fuel and emission control systems

Pcm configuration

In this manual: Fuel and emission control systems
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Connect the WDS to DLC-2.

2. Set up the WDS (including the vehicle recognition.)


3. Select Module programming.

4. Select Programmable module installation.

5. Select PCM and perform procedures according to directions on the WDS screen.

Note
  • If PCM CONFIGURATION is successful, the PCM stores the DTC P0602 and illuminates the MIL. (System is normal.) Clear the DTC P0602 using WDS or equivalent after PCM CONFIGURATION.
Note
  • MIL goes off after three drive cycles with no failure. (DTCs remain in PCM.)

6. Retrieve DTCs by the WDS or equivalent, then verify that there in no DTC present.

  • If DTC is present, perform applicable DTC inspection.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.