Mazda 6 Quiz
Fuel and emission control systems

Clutch switch inspection

In this manual: Fuel and emission control systems
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Note
  • Perform the following inspection only when directed.
Continuity Inspection

1. Verify that the clutch switch is installed properly.

2. Disconnect the negative battery cable.

3. Remove the clutch switch.

4. Inspect for continuity between the clutch switch terminals using an ohmmeter.

  • If the clutch switch is okay, but CPP PID value is out of specification, carry out of the Clutch Switch Circuit Open/Short Inspection.
  • If not as specified, replace the clutch switch.

Specification

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)


2. Inspect the following harness for open or short. (Continuity check)

Open circuit
  • Clutch switch terminal B (harness-side) and PCM terminal 1R
  • Clutch switch terminal D and body GND
Short circuit
  • Clutch switch terminal B (harness-side) and power supply
  • Clutch switch terminal B (harness-side) and body GND

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.