Driver Information & Multimedia

Additional Service When Replacing Around View Monitor Control Unit

2steps
~12min
2/5difficulty
Done 0 of 2

Description

Perform the following operations when replacing around view monitor control unit. For details, refer to Work Procedure.

AFTER REPLACEMENT

When after replacing around view monitor control unit, the following items must be performed. Or not doing so, around view monitor system does not operate normally.

  • Writing MAC key

  • Configuration

  • Camera calibration

Work Procedure

Perform the following procedures after replacing the around view monitor control unit.

REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to Removal and Installation.

>>

GO TO 2.

WRITING MAC KEY

With CONSULT

Perform MAC key writing. Refer to Description.

>>

GO TO 3.

PERFORM CONFIGURATION

With CONSULT

Perform "Replace ECU".

>>

GO TO 4.

WRITING OF CALIBRATION DATA

Write the calibration data stored in the camera using CONSULT. Refer to Work Procedure.

>>

GO TO 5.

PERFORM SELF-DIAGNOSIS

  1. Perform the self-diagnosis of around view monitor control unit with CONSULT (AROUND VIEW MONITOR).

  2. Check if any DTC is detected.

Is any DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.

NO>>

GO TO 6.

OPERATION CHECK

Confirm that the operation of the around view monitor and the camera image (reference line, expected route) are normal.

>>

WORK END