Driver Information & Multimedia
Writing of Calibration Data
In this manual: Driver Information & Multimedia
2steps
~12min
1/5difficulty
Done 0 of 2
Work Procedure
DESCRIPTION
If only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.
WORK PROCEDURE
WRITE CALIBRATION DATA
With CONSULT
Select "CALIBRATING CAMERA IMAGE" of "Work Support" mode using CONSULT.
After displaying the status, check that the status is displayed as "Normal".
Is the status of each camera displayed as "Normal"?
YES>>INSPECTION END
NO>>Calibrate the camera that is not displayed as "normal". Refer to Work Procedure.
Was this page helpful?