Brake Caliper Assembly
Exploded View
REMOVAL

| Brake caliper assembly | |||||
| : N·m (kg-m, ft-lb) |
DISASSEMBLY

| Cap | Bleeder valve | Cylinder body | |||
| Sliding pin | Sliding pin boot | Bushing | |||
| Torque member | |||||
| : vehicle front | |||||
| : N·m (kg-m, in-lb) | |||||
| : Apply rubber grease. | |||||
Removal and Installation
REMOVAL
Release the parking brake.
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Perform the advance preparation "(Air release) Accumulator pressure release" using CONSULT. Refer to Work Procedure.
Remove parking brake actuator harness and rear wheel sensor. Hang parking brake actuator harness and rear wheel sensor not to interfere with work. Refer to Removal and Installation.
Fix the disc rotor using wheel nuts.
Drain brake fluid. Refer to Draining.
Remove union bolt and copper washer, and separate brake hose from brake caliper assembly. Refer to Removal and Installation.
Remove sliding pin bolts
, and remove the cylinder body.

Remove torque member mounting bolts, and remove torque member.
Remove disc rotor. Refer to Removal and Installation.
INSTALLATION
Install disc rotor. Refer to Removal and Installation.
Install the torque member to the steering knuckle and tighten the torque member mounting bolts to the specified torque. Refer to Exploded View.
Install the cylinder body to the torque member and tighten the sliding pin bolts
to the specified torque. Refer to Exploded View.

Install brake hose and copper washers to brake caliper assembly. Refer to Removal and Installation.
Refill with new brake fluid and perform the air bleeding. Refer to Work Procedure.
Never spill or splash brake fluid on the surface of disc rotor.
Must be performed additional service when replacing brake caliper assembly. Refer to Description.
Check a drag of rear disc brake. If any drag is found, refer to Inspection and Adjustment.
Install tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Perform inspection after installation. Refer to Inspection.
Disassembly and Assembly
DISASSEMBLY
Remove the sliding pin bolt, and remove the cylinder body from the torque member. Refer to Removal and Installation.
Remove sliding pins and sliding pin boots from torque member.
Remove bushing
from sliding pin
.

Remove bleeder valve and cap.
Perform inspection after disassembly. Refer to Inspection.
ASSEMBLY
Install bleeder valve and cap.
Apply rubber grease to mating faces
between sliding pin
and bushing
, and install bushing to sliding pin.

Apply rubber grease to mating faces
between sliding pins
and sliding pin boots
, and install sliding pins and sliding pin boots to torque member
.

Install the cylinder body to tighten cylinder body mounting bolts to the specified torque. Refer to Exploded View.
Inspection
INSPECTION AFTER DISASSEMBLY
Check the following items and replace if necessary.
Cylinder Body
Check the cylinder inner wall for rust, wear, cracks or damage.
Torque Member
Check the torque member for rust, wear, cracks or damage.
Sliding Pin, Sliding Pin Boot and Bushing
Check the sliding pins, sliding pin boots and bushing for rust, wear, cracks or damage.
INSPECTION AFTER INSTALLATION
Check a drag of rear disc brake. If any drag is found, follow the procedure described below.
Remove brake pads. Refer to Removal and Installation.
Press the pistons. Refer to Removal and Installation.
Install brake pads. Refer to Removal and Installation.
Depress the brake pedal several times.
Check a drag of rear disc brake again. When any drag is found, disassemble the cylinder body and replace if necessary. Refer to Disassembly and Assembly.
Burnish contact surfaces brake pads and disc rotor after refinishing or replacing disc rotor, or if a soft pedal occurs at very low mileage. Refer to Inspection and Adjustment.