Brake Pad
Exploded View

| Cylinder body | Inner shim cover | Inner shim | |||
| Inner pad (with pad wear sensor) | Return spring | Pad retainer | |||
| Torque member | Outer pad | Outer shim | |||
| Outer shim cover | |||||
| : vehicle front | |||||
Molykote is a registered trademark of Dow Corning Corporation.
Removal and Installation
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove lower sliding pin bolt
, and remove cylinder body.

Suspend the cylinder body with suitable wire so that the brake hose will not stretch.
Remove the brake pads, shims, shim covers and pad retainer
(with return spring
) from the torque member
.

Remove the return springs
from the pad retainer
.

Perform inspection after removal. Refer to Inspection.
INSTALLATION
Install the return springs
to pad retainer
if the return springs has been removed.

Apply MOLYKOTE® 7439 or equivalent to the match face
between the pad retainers
and torque member
if the pad retainers has been removed.

Molykote is a registered trademark of Dow Corning Corporation.
Install the pad retainer
(with return spring
) to torque member
if the pad retainers has been removed.

Apply MOLYKOTE® AS880N or siliconebased grease to the both face
of shim
, and install the shim and the shim covers
to the brake pad
.

Molykote is a registered trademark of Dow Corning Corporation.
Install the brake pads
to the torque member
.

Apply MOLYKOTE® AS880N or siliconebased grease to the claw parts
of cylinder body.

Molykote is a registered trademark of Dow Corning Corporation.
Install cylinder body to torque member.
Install the lower sliding pin bolt and tighten it to the specified torque. Refer to Exploded View.
Depress the brake pedal several times to check that no drag feel is present for the front disc brake. Refer to Inspection and Adjustment.
Install tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Inspection
INSPECTION AFTER REMOVAL
Replace the shims and shim covers if rust is excessively attached.
Eliminate rust on the return spring, pad retainers and the torque member. Replace them if rust is excessively attached.
INSPECTION AFTER INSTALLATION
Check a drag of front disc brake. If any drag is found, follow the procedure described below.
Remove brake pads. Refer to Removal and Installation.
Press the pistons.
Install brake pads. Refer to Removal and Installation.
Depress the brake pedal several times.
Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body. Refer to FRONT BRAKE CALIPER ASSEMBLY : Disassembly & Assembly.
Burnish contact surfaces brake pads and disc rotor after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Refer to Inspection and Adjustment.