Body Exterior, Doors, Roof & Vehicle Security

Front Door Glass

~2min read

Removal and Installation

REMOVAL

Remove front door pull handle bracket. Refer to Removal and Installation.

Remove front door sash inner cover. Refer to Removal and Installation.

Remove hole seals from front door panel.

Reconnect power window main switch connector with front door finisher.

Operate power window main switch to raise or lower front door glass until front door glass fixing pawl positions can be seen.

Disengage front door glass fixing pawls of front door module assembly using a removal tool (B) according to numerical order 1→2 indicated by arrows as shown in the figure.

: Pawl
: vehicle front

Pull up front door glass to upward, and then remove front door glass.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Inspection and Adjustment

SYSTEM INITIALIZATION

Perform additional service for operating the power window control system normally after installing front door glass. Refer to Work Procedure.

FITTING INSPECTION

  • Check that glass is fitted securely into the sash groove.

  • Lower glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each fastener to correct the glass position if the clearance between the glass and sash are not parallel.