Multi-Way Control Valve
Exploded View

| Multi-way control valve | O-ring | Water outlet | |||
| Engine coolant temperature sensor 1 | Gasket | ||||
| To oil cooler hose 1. Refer to Exploded View. | To electric water pump. Refer to Exploded View. | To radiator. Refer to RADIATOR : Exploded View. | |||
| To electric throttle control actuator. Refer to Exploded View. | |||||
| : N·m (kg-m, ft-lb) | |||||
| : Always replace after every disassembly. |
Removal & Installation
REMOVAL
Remove engine cover. Refer to Removal and Installation.
Remove front under cover using a power tool. Refer to Removal and Installation.
Drain engine coolant. Refer to ENGINE COOLANT : Draining.
Remove air inlet tube 2. Refer to Removal & Installation.
Remove inlet air duct 2. Refer to Removal and Installation.
Remove electric throttle control actuator. Refer to Removal and Installation.
Remove radiator hose (upper)
from multi-way control valve
side.

Remove each remaining hose connected to the multi-way control valve.
Remove multi-way control valve.
INSTALLATION
Note the following, and install in the reverse order of removal.
Inspection
INSPECTION AFTER INSTALLATION
Check that the reservoir tank cap is tightened.
Check for leakage of engine coolant using the radiator cap tester adapter (commercial service tool) and the radiator cap tester (commercial service tool). Refer to ENGINE COOLANT : Inspection.
Start and warm up the engine. Visually check that there is no leakage of engine coolant.