Driver Controls

Rear Combination Lamp

~2min read

Exploded View

Grommet Rear combination lamp Rear combination lamp cover
: Clip
: Pawl
: N·m (kg-m, in-lb)

Removal and Installation

REMOVAL

Fully open back door.

Apply protective tape (A) on the part to protect it from damage.

Disengage rear combination lamp cover fixing pawls using a remover tool (A), and then remove rear combination lamp cover.

: Pawl

Remove rear combination lamp mounting bolts .

Apply protective tape (A) on the part to protect it from damage.

Disengage combination lamp fixing clips using a remover tool (A).

: Clip

Remove grommet .

Disconnect rear combination lamp harness connector .

Remove rear combination lamp.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

Replacement

TAIL LAMP/STOP LAMP

TAIL LAMP

STOP LAMP

REAR TURN SIGNAL LAMP

BACK-UP LAMP

REAR SIDE MARKER LAMP