Driver Controls
Tail Lamp
In this manual: Driver Controls
~1min read
Exploded View

| Back door panel | Tail lamp LH | Grommet | |||
| Tail lamp RH | |||||
| : Clip | |||||
| : N·m (kg-m, in-lb) | |||||
Removal and Installation
REMOVAL
Remove back door finisher. Refer to Removal and Installation.
Remove rear emblem and rear emblem bracket. Refer to Removal and Installation.
Disconnect tail lamp harness connectors
.

Remove tail lamp mounting nuts
.

Apply protective tapes (A) on the part to protect it from damage.

Disengage tail lamp RH fixing clip using a remover tool (A).

| : Clip |
Disengage tail lamp RH fixing clip using a remover tool (A).

| : Clip |
Remove grommet
, and then remove tail lamp RH.

Apply protective tapes (A) on the part to protect it from damage.

Disengage tail lamp LH fixing clip using a remover tool (A).

| : Clip |
Disengage tail lamp LH fixing clip using a remover tool (A).

| : Clip |
Remove grommet
, and then remove tail lamp LH.

INSTALLATION
Note the following item, and then install in the reverse order of removal.
Replacement
TAIL LAMP
Was this page helpful?