Front fog lamp circuit
Component Function Check
1.CHECK FRONT FOG LAMP OPERATION
CONSULT-III ACTIVE TEST
1. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
2. With operating the test items, check that the front fog lamp is turned ON.
Fog : Front fog lamp ON Off : Front fog lamp OFF
Is the measurement normal? YES >> Front fog lamp circuit is normal.
NO >> Refer to EXL-54, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK FRONT FOG LAMP FUSE 1. Turn ignition switch OFF.2. Check that the following fuse is not fusing.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK FRONT FOG LAMP SHORT CIRCUIT 1. Disconnect front fog connector and IPDM E/R connector.2. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> Replace fuse. (Replace IPDM E/R if the fuse is fusing again.) NO >> Repair or replace harness. And then replace the fuse.
3.CHECK FRONT FOG LAMP BULBCheck the applicable lamp bulb.
Is the inspection result normal? YES >> GO TO 4.
NO >> Replace bulb.
4.CHECK FRONT FOG LAMP OUTPUT VOLTAGE
CONSULT-III ACTIVE TEST
1. Disconnect front fog lamp connector. 2. Turn ignition switch ON. 3. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
4. With operating the test items, check the voltage between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> GO TO 5.
NO >> Replace IPDM E/R.
5.CHECK FRONT FOG LAMP OPEN CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R connector.3. Check continuity between IPDM E/R harness connector and front fog lamp harness connector.

Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace harness.
6.CHECK FRONT FOG LAMP GROUND CIRCUIT OPEN CIRCUITCheck continuity between front fog lamp harness connector and grou

Is the inspection result normal? YES >> Refer to GI-42, "Intermittent Incident".
NO >> Repair or replace harness.