Headlamp (LO) circuit
Component Function Check
1.CHECK HEADLAMP (LO) OPERATION
CONSULT-III ACTIVE TEST
1. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
2. With operating the test items, check that the headlamp (LO) is turned ON.
Lo : Headlamp (LO) ON Off : Headlamp (LO) OFF
Is the inspection result normal? YES >> Headlamp (LO) is normal.
NO >> Refer to EXL-47, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK HEADLAMP (LO) OUTPUT VOLTAGE
CONSULT-III ACTIVE TEST
1. Turn ignition switch OFF. 2. Disconnect headlamp connector. 3. Turn ignition switch ON. 4. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
5. With operating the test items, check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 3.
2.CHECK HEADLAMP (LO) OPEN CIRCUIT 1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector and headlamp harness connector.

Is the inspection result normal? YES >> Replace headlamp bulb.
NO >> Repair or replace harness.
3.CHECK HEADLAMP (LO) FUSE 1. Turn ignition switch OFF.2. Check that the following fuses are not fusing.

Is the inspection result normal? YES >> Replace IPDM E/R.
NO >> GO TO 4.
4.CHECK HEADLAMP (LO) SHORT CIRCUIT 1. Disconnect IPDM E/R connector.2. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> Replace the fuse. (Replace IPDM E/R if the fuse is fusing again.) NO >> Repair or replace harness. And then replace the fuse.