Transaxle & transmissioN CVT: RE0F11A
Stall test
In this manual: Transaxle & transmissioN CVT: RE0F11A
~1min read
Work Procedure
INSPECTION
1. Check the engine oil level. Replenish if necessary. Refer to LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80 °C. 4. Be sure to apply the parking brake and block the tires. 5. Start the engine, depress the brake pedal and put the selector lever to the D position. 6. While depressing the brake pedal, depress the accelerator pedal gradually.7. Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
CAUTION:Never depress the accelerator pedal for 5 seconds or more during the test.
Stall speed : Refer to TM-512, "Stall Speed".
8. Place the selector lever in the N position.9. Cool the CVT fluid.
CAUTION:Run the engine with the idle speed for at least 1 minute.
10. Put the selector lever to the R position and perform Step 6 to Step 9 again.
NARROWING-DOWN MALFUNCTIONING PARTS

O: Within the stall speed standard value H: Stall speed is higher than the standard value.
L: Stall speed is lower than the standard value.
Was this page helpful?