Driver Information & Multimedia

Av Control Unit

5steps
~30min
2/5difficulty
Done 0 of 5
Diagnosis Procedure

CHECK FUSE

Check that the following fuses are not blown:

Terminal No.Signal nameFuse No.Capacity
7 ACC power supply 7 10 A
17 Ignition power supply 29 10 A
19 Battery power supply 15 20 A

Are the fuses blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK POWER SUPPLY CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect AV control unit connectors.

  3. Check voltage between AV control unit connectors and ground.

    AV control unitGroundCondition

    Voltage

    (Approx.)
    ConnectorTerminal
    M161 19 — Ignition switch: OFF Battery voltage
    7 Ignition switch: ON
    17

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

CHECK GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Check continuity between AV control unit connector and ground.

    AV control unitGroundContinuity
    ConnectorTerminal
    M161 20 — Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connectors.