Electrical & Power Control

B259a Room Lamp Fuse Blown

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B259A

ROOM LAMP FUSE BLOWN

(Room lamp fuse blown)
Diagnosis condition When ignition switch ON.
Signal (terminal) BCM power circuit (terminal 131 and ground)
Threshold Approx. 0V
Diagnosis delay time 120 seconds or more

POSSIBLE CAUSE

  • Fuse

  • Harness or connector (power supply circuit is open or shorted)

  • Harness or connector (interior room lamp power supply circuit is shorted)

  • BCM

FAIL-SAFE

—

DTC Confirmation Procedure

DTC CONFIRMATION PROCEDURE

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Select the “Self Diagnostic Result” mode of “BCM”, after ignition switch ON for 120 seconds or more.

  4. Check DTC.

Is any DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK FUSE

Check that the following fuse is not blown:

Terminal No.Signal nameFuse No.Capacity
131 BCM battery fuse 1 10A

Is the fuse or fusible link blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK BAT BCM FUSE CIRCUIT

  1. Disconnect BCM connector.

  2. Check voltage between BCM harness connector and ground.

    (+) (–)

    Voltage

    (Approx.)
    BCM
    Connector Terminal
    M81 131 Ground Battery voltage

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors. GO TO 3.

CHECK BATTERY SAVER OUTPUT CIRCUIT FOR SHORT TO GROUND

  1. Ignition switch OFF.

  2. Disconnect following connectors:

    • Automatic back door close switch (if equipped)

    • Luggage room lamp

    • Vanity lamp LH

    • Vanity lamp RH

    • Front room/map lamp assembly

    • Personal lamp 2ND row LH

    • Personal lamp 2ND row RH

  3. Check continuity between BCM harness connector and ground.

    BCM Ground Continuity
    Connector Terminal
    M81 129 No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.