Electrical & Power Control
Power Supply and Ground Circuit
In this manual: Electrical & Power Control
2steps
~12min
1/5difficulty
Done 0 of 2
CHECK FUSE AND FUSIBLE LINK
Check that the following fuse and fusible link are not blown:
| Terminal | Signal name | Fuse or fusible link No. | Capacity |
|---|---|---|---|
| 25 | Battery power supply (brake switch) | 10 | 10A |
| 26 | Battery power supply (shorting input) | 16 | 5A |
| 81 | Battery power supply (rear wiper) | 5 | 15A |
| 131 | Battery power supply | 1 | 10A |
| 138 | Battery power supply (rear door) | 4 | 15A |
| 139 | Battery power supply | L | 40A |
| 142 | Battery power supply (front door) | 3 | 15A |
Is the fuse or fusible link blown?
YES>>Replace the blown fuse or fusible link after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Disconnect BCM connectors.
Check voltage between BCM harness connectors and ground.
(+) (–) Voltage
(Approx.)BCM Connector Terminal M18 25 Ground Battery voltage 26 M20 81 M81 131 138 139 142
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Check continuity between BCM harness connector and ground.
| BCM | Ground | Continuity | |
| Connector | Terminal | ||
| M81 | 134 | Yes | |
| 143 | |||
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?