Cruise Control & Driver Assistance

C1b0a-16 Power Supply Circuit2

3steps
~18min
2/5difficulty
Done 0 of 3
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1B0A-16

POWER SUPPLY CIRCUIT2

(Power supply circuit)
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold Lane camera unit ignition voltage is less than 10.5V.
Diagnosis delay time 5 seconds or more.

POSSIBLE CAUSE

  • Harness, connector or fuse

  • Lane camera unit

  • Power supply circuit

FAIL-SAFE

The following functions are suspended:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

  • Automatic Emergency Braking (AEB) with pedestrian detection

  • Automatic Emergency Braking (AEB)

  • Rear Automatic Braking (RAB)

  • Traffic Sign Recognition (TSR)

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Perform “All DTC Reading”.

  3. Check if “C1B0A-16” is detected as the current malfunction on the “Self Diagnostic Result” of “LANE CAMERA”.

Is “C1B0A-16” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK LANE CAMERA UNIT SUPPLY AND GROUND CIRCUIT

Check power supply and ground circuit of lane camera unit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace the lane camera unit. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.