Cruise Control & Driver Assistance

U1010-49 Control Unit (can)

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DESCRIPTION

CAN controller controls the communication of ITS communication signal and the error detection.

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

U1010-49

CONTROL UNIT (CAN)

[Control unit (CAN)]
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold If lane camera unit detects malfunction by CAN controller initial diagnosis.
Diagnosis delay time 5 seconds or more.

POSSIBLE CAUSE

Lane camera unit

FAIL-SAFE

The following systems are canceled:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

  • Automatic Emergency Braking (AEB) with pedestrian detection

  • Automatic Emergency Braking (AEB)

  • Traffic Sign Recognition (TSR)

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Turn the AEB or LDW system ON.

  3. Perform “All DTC Reading”.

  4. Check if “U1010-49” is detected as the current malfunction in “Self Diagnostic Result” of “LANE CAMERA”.

Is “U1010-49” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Turn the AEB or LDW system ON.

  2. Perform “All DTC Reading”.

  3. Check if “U1010-49” is detected as the current malfunction in “Self Diagnostic Result” of “LANE CAMERA”.

Is “U1010-49” detected as the current malfunction?

YES>>

Replace the lane camera unit. Refer to Removal and Installation.

NO>>

Inspection End.