Diagnosis and Repair Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving Nissan Murano vehicle with customer, if necessary.
>>GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by protection function. Refer to Protection Function.
>>GO TO 3.
SELECT SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.
Is any DTC detected?
YES>>Record or print self-diagnosis results. GO TO 4.
NO>>GO TO 6.
RECHECK SYMPTOM
CONSULT
Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.
Perform DTC confirmation procedures for the error detected system.
Is any DTC detected?
YES>>GO TO 5.
NO>>Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.
REPAIR OR REPLACE ERROR-DETECTED PARTS
CONSULT
Repair or replace error-detected parts.
Reconnect part or connector after repairing or replacing.
When DTC is detected, erase “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.
GO TO 7.
IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSIS
Estimate error-detected system based on symptom diagnosis and perform inspection.
Can the error-detected system be identified?
YES>>GO TO 7.
NO>>Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.
FINAL CHECK
CONSULT
Check the reference value for AWD control unit.
Recheck the symptom and check that symptom is not reproduced on the same conditions.
Is the symptom reproduced?
YES>>GO TO 3 .
NO>>Inspection End.
Description
In general, customers have their own criteria for a problem. Therefore, it is important to understand the symptom and status well enough by asking the customer about his/her concerns carefully. To systemize all the information for the diagnosis, prepare the interview sheet referring to the interview points.
In some cases, multiple conditions that appear simultaneously may cause a DTC to be detected.
Interview sheet sample
| Interview sheet | |||||
|---|---|---|---|---|---|
| Customer name | MR/MS | Registration number | Initial year registration | ||
| Nissan Murano Vehicle type | VIN | ||||
| Storage date | Engine | Mileage | km (Mile) | ||
| Symptom | □Nissan Murano Vehicle does not enter AWD mode. | ||||
| □AWD warning icon/display is displayed. | |||||
| □Heavy tight-corner braking symptom occurs | |||||
| □Noise □Vibration | |||||
□Others ( ) |
|||||
| First occurrence | □Recently □Others ( ) | ||||
| Frequency of occurrence | □Always □Under a certain conditions of □Sometimes (time(s)/day) | ||||
| Climate conditions | □Irrelevant | ||||
| Weather | □Fine □Cloud □Rain □Snow □Others ( ) | ||||
| Temperature | □Hot □Warm □Cool □Cold □Temperature (Approx. °C) | ||||
| Relative humidity | □High □Moderate □Low | ||||
| Road conditions | □Urban area □Suburb area □High way □Mounting road (uphill or down hill) □Rough road |
||||
| Operation conditions, etc. | □Irrelevant □When engine starts □During idling □During driving □During acceleration □At constant speed driving □During deceleration □During cornering (right curve or left curve) |
||||
| Other conditions | |||||
Memo |
|||||