Transmission & Driveline
Drive Shaft Oil Seal
In this manual: Transmission & Driveline
~1min read

| 1. | Transfer case assembly | 2. | Drive shaft oil seal | 3. | Transfer cover oil seal |
REMOVAL
Remove the front drive shaft (RH). Refer to Removal & Installation.
Remove bolts and remove front drive shaft support bracket (RH). Refer to Exploded View.
Using a suitable tool, remove the transfer cover oil seal.
Remove the drive shaft oil seal (1) using suitable tool (A).

INSTALLATION
Install drive shaft oil seal (1) onto Tool (A) before installing into transfer case assembly using Tool (B).

| Tool (A) | : — (J-52390) |
| Tool (B) | : — (J-8092) |
Using two people, install the drive shaft oil seal (1) to the specified depth (A).

| Dimension (A) | : 2.0 - 2.6 mm (0.079 - 0.102 in) |
Using two people, install the transfer cover oil seal (1) using suitable tool (A).

Verify the transfer cover oil seal (2) is installed to the correct depth (A).

| Dimension (A) | : 0.0 - 0.6 mm (0.000 - 0.024 in) |
| (1) | : Drive shaft oil seal |
| (B) | : Drive shaft oil seal installation depth |
Installation of the remaining components is in the reverse order of removal.
Was this page helpful?