Electrical & Power Control
Intelligent Key
In this manual: Electrical & Power Control
~8min read
ECU IDENTIFICATION
The BCM part number is displayed.
SELF DIAGNOSTIC RESULT
Refer to DTC Index.
DATA MONITOR
| Monitor Item [Unit] | Main | Description |
|---|---|---|
| REQ SW -DR [On/Off] | × | Indicates condition of door request switch LH. |
| REQ SW -AS [On/Off] | × | Indicates condition of door request switch RH. |
| REQ SW -BD/TR [On/Off] | × | Indicates condition of back door request switch. |
| PUSH SW [On/Off] | Indicates condition of push-button ignition switch. | |
| SHFTLCK SLNID PWR SPLY [On/Off] | × | Indicates condition of power supply to shiftlock solenoid. |
| CLUSH SW [On/Off] | ||
| BRAKE SW 1 [On/Off] | × | Indicates condition of brake switch. |
| BRAKE SW 2 [On/Off] | Indicates condition of brake switch. | |
| DETE/CANCL SW [On/Off] | × | Indicates condition of P (park) position. |
| SFT PN/N SW [On/Off] | × | Indicates condition of P (park) or N (neutral) position. |
| UNLK SEN -DR [On/Off] | × | Indicates condition of door unlock sensor. |
| PUSH SW -IPDM [On/Off] | Indicates condition of push-button ignition switch received from IPDM E/R on CAN communication line. | |
| IGN RLY1 -F/B [On/Off] | Indicates condition of ignition relay-1 received from IPDM E/R on CAN communication line. | |
| DETE SW -IPDM [On/Off] | Indicates condition of park position switch received from TCM on CAN communication line. | |
| SFT PN -IPDM [On/Off] | Indicates condition of P (park) or N (neutral) position from TCM on CAN communication line. | |
| SFT P -MET [On/Off] | Indicates condition of P (park) position from TCM on CAN communication line. | |
| SFT N -MET [On/Off] | Indicates condition of N (neutral) position from IPDM E/R on CAN communication line. | |
| ENGINE STATE [Stop/Start/Crank/Run] | × | Indicates condition of engine state from ECM on CAN communication line. |
| VEH SPEED 1 [mph/km/h] | × | Indicates condition of Nissan Murano vehicle speed signal received from ABS on CAN communication line. |
| VEH SPEED 2 [mph/km/h] | × | Indicates condition of Nissan Murano vehicle speed signal received from combination meter on CAN communication line. |
| DOOR STAT -DR [LOCK/READY/UNLK] | × | Indicates condition of driver side door status. |
| DOOR STAT -AS [LOCK/READY/UNLK] | × | Indicates condition of passenger side door status. |
| DOOR STAT -RR [LOCK/READY/UNLK] | × | Indicates condition of rear right side door status. |
| DOOR STAT -RL [LOCK/READY/UNLK] | × | Indicates condition of rear left side door status. |
| BK DOOR STATE [LOCK/READY/UNLK] | × | Indicates condition of back door status. |
| ID OK FLAG [Set/Reset] | Indicates condition of Intelligent Key ID. | |
| PRMT ENG STRT [Set/Reset] | Indicates condition of engine start possibility. | |
| PRMT RKE STRT [Set/Reset] | Indicates condition of engine start possibility from Intelligent Key. | |
| I-KEY OK FLAG [Key ON/Key OFF] | × | Indicates condition of Intelligent Key OK flag. |
| PRBT ENG STRT [Set/Reset] | Indicates condition of engine start prohibit. | |
| ID AUTHENT CANCEL TIMER [under a stop] | Indicates condition of Intelligent Key ID authentication. | |
| ACC BATTERY SAVER [under a stop] | Indicates condition of battery saver. | |
| CRNK PRBT TMR [On/Off] | Indicates condition of crank prohibit timer. | |
| AUT CRANK TMR [On/Off] | Indicates condition of automatic engine crank timer from Intelligent Key. | |
| CRNK PRBT TME [sec] | Indicates condition of engine crank prohibit timer. | |
| AUT CRANK TMR [sec] | Indicates condition of automatic engine crank timer from Intelligent Key. | |
| CRANKING TME [sec] | Indicates condition of engine cranking time from Intelligent Key. | |
| SHORT CRANK [NG] | ||
| ST RLY -REQ [On/Off] | Indicates condition of starter relay. | |
| IGN RLY 1 -REQ [On/Off] | Indicates condition of ignition 1 relay. | |
| IGN RLY 2 -REQ [On/Off] | Indicates condition of ignition 2 relay. | |
| DETE SW PWR [On/Off] | Indicates condition of park position switch voltage. | |
| IGN RLY3 -REQ [On/Off] | Indicates condition of front blower motor relay control signal. | |
| ACC RLY -REQ [On/Off] | Indicates condition of accessory relay control request. | |
| RKE OPE COUN1 [0-19] | × | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. |
| RKE OPE COUN2 [0-19] | × | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. |
| TRNK/HAT MNTR [On/Off] | Indicates condition of luggage room lamp switch. | |
| RKE-LOCK [On/Off] | Indicates condition of lock signal from Intelligent Key. | |
| RKE-UNLOCK [On/Off] | Indicates condition of unlock signal from Intelligent Key. | |
| RKE-TR/BD [On/Off] | Indicates condition of back door open signal from Intelligent Key. | |
| RKE-PANIC [On/Off] | Indicates condition of panic signal from Intelligent Key. | |
| RKE-MODE CHG [On/Off] | Indicates condition of mode change signal from Intelligent Key. | |
| RKE PBD | Indicates condition of power back door signal from Intelligent Key. |
ACTIVE TEST
| Test Item | Description |
|---|---|
| INTELLIGENT KEY LINK (CAN) | This test is able to check Intelligent Key identification number [Off/ID No1/ID No2/ID No3/ID No4/ID No5]. |
| INT LAMP | This test is able to check interior room lamp operation [On/Off]. |
| FLASHER | This test is able to check hazard lamp operation [LH/RH/Off]. |
| HORN | This test is able to check horn operation [On]. |
| BATTERY SAVER | This test is able to check battery saver operation [On/Off]. |
| TRUNK/BACK DOOR | This test is able to check back door actuator operation [Open]. |
| OUTSIDE BUZZER | This test is able to check Intelligent Key warning buzzer operation [On/Off]. |
| INSIDE BUZZER | This test is able to check combination meter warning chime operation [Take Out/Knob/Key/Off]. |
| INDICATOR | This test is able to check combination meter warning lamp operation [KEY ON/KEY IND/Off]. |
| IGN CONT2 | This test is able to check ignition relay-2 control operation [On/Off]. |
| ENGINE SW ILLUMI | This test is able to check push-button ignition switch START indicator operation [On/Off]. |
| PUSH SWITCH INDICATOR | This test is able to check push-button ignition switch indicator operation [On/Off]. |
| ACC CONT | This test is able to check accessory relay control operation [On/Off]. |
| IGN CONT1 | This test is able to check ignition relay-1 control operation [On/Off]. |
| ST CONT LOW | This test is able to check starter control relay operation [On/Off]. |
| IGNITION RELAY | This test is able to check ignition relay operation [On/Off]. |
| REVERSE LAMP TEST | This test is able to check reverse lamp illumination operation [On/Off]. |
| DOOR HANDLE LAMP TEST | This test is able to check door handle lamp illumination operation [On/Off]. |
| TRUNK/LUGGAGE LAMP TEST | This test is able to check cargo lamp illumination operation [On/Off]. |
| KEYFOB P/W TEST | This test is able to check power window operation using the Intelligent Key [Off/DOWN/UP]. |
| SHIFTLOCK SORENOID TEST | This test is able to check shift lock solenoid operation [On/Off]. |
| DR SEAT LAMP TEST | This test is able to check driver side map lamp illumination operation [On/Off]. |
| AS SEAT LAMP TEST | This test is able to check passenger side map lamp illumination operation [On/Off]. |
| SHIFT SPOT LAMP TEST | This test is able to check mood lamp illumination operation [On/Off]. |
WORK SUPPORT
| Support Item | Setting | Description | |
|---|---|---|---|
| IGN/ACC BATTERY SAVER | On* | Battery saver function ON. | |
| Off | Battery saver function OFF. | ||
| REMOTE ENGINE STARTER | On* | Remote engine start function ON. | |
| Off | Remote engine start function OFF. | ||
| ANSWER BACK I-KEY LOCK UNLOCK | BUZZER* | Buzzer reminder function by door lock/unlock request switch ON. | |
| HORN | Horn chirp reminder function by door lock request switch ON. | ||
| Off | No reminder function by door lock/unlock request switch. | ||
| INVALID | This mode is not used. | ||
| ANSWERBACK KEYLESS LOCK UNLOCK | On* | Buzzer or horn chirp reminder when doors are locked/unlocked with Intelligent Key. | |
| Off | No buzzer or horn chirp reminder when doors are locked/unlocked with Intelligent Key. | ||
| ANSWER BACK | On* | Horn chirp reminder when doors are locked with Intelligent Key. | |
| Off | No horn chirp reminder when doors are locked with Intelligent Key. | ||
| LOCK/UNLOCK BY I-KEY | On* | Door lock/unlock function from Intelligent Key ON. | |
| Off | Door lock/unlock function from Intelligent Key OFF. | ||
| ENGINE START BY I-KEY | On* | Engine start function from Intelligent Key ON. | |
| Off | Engine start function from Intelligent Key OFF. | ||
| TRUNK/GLASS HATCH OPEN | On* | Buzzer reminder function by back door request switch ON. | |
| Off | Buzzer reminder function by back door request switch OFF. | ||
| CONFIRM KEY FOB ID | — | Intelligent Key ID code can be checked. | |
| SHORT CRANKING OUTPUT | Start | 70 msec | Starter motor operation duration times. |
| 100 msec | |||
| 200 msec | |||
| End | — | ||
| INSIDE ANT DIAGNOSIS | — | This function allows inside key antenna self-diagnosis. | |
| AUTO LOCK SET | MODE7 | 5 min | Auto door lock time can be set in this mode. |
| MODE6 | 4 min | ||
| MODE5 | 3 min | ||
| MODE4 | 2 min | ||
| MODE3* | 1 min | ||
| MODE2 | 30 sec | ||
| MODE1 | Off | ||
| BCM diagnosis when engine does not start | — | This function allows engine start function self-diagnosis. | |
| BCM diagnosis when the door lock is malfunctioning | — | This function allows door lock function self-diagnosis. | |
| Keyless power window function setting | DOWN* | Keyless power window down function set ON. | |
| Off | Keyless power window down function set OFF. | ||
*: Initial Setting
Was this page helpful?