Driver Information & Multimedia
Power Supply and Ground Circuit
In this manual: Driver Information & Multimedia
5steps
~30min
2/5difficulty
Done 0 of 5
CHECK FUSE
Check that the following fuses are not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 40 | Ignition signal | 29 | 10 A |
Are the fuses blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect around view monitor control unit connector.
Check voltage between around view monitor control unit connector and ground.
Around view monitor control unit Ground Condition Voltage
(Approx.)Connector Terminal M96 40 — Ignition switch: ON Battery voltage
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Ignition switch OFF.
Check continuity between around view monitor control unit connector and ground.
Around view monitor control unit Ground Continuity Connector Terminal M96 39 — Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?