Driver Information & Multimedia

U1010 Control Unit(can)

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1010

CONTROL UNIT(CAN)

[Control unit(CAN)]
Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

Around view monitor control unit

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “AVM”.

  3. Check DTC.

Is DTC U1010 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of “AVM”.

  4. Check DTC.

Is DTC U1010 detected?

YES>>

Replace around view monitor control unit. Refer to Removal and Installation.

NO>>

Inspection End.