Engine

Thermostat and Thermostat Housing

~2min read
Exploded View
1. Gasket 2. Thermostat assembly (water inlet)
Removal and Installation

REMOVAL

Drain engine coolant from radiator. Refer to Changing Engine Coolant.

Drain power steering fluid. Refer to Draining and Refilling.

Remove front under cover. Refer to Removal and Installation.

Disconnect intake valve timing control solenoid valve (LH) harness connector.

Remove the E-PSF cover, bracket and motor. Refer to Removal and Installation.

Remove the lower radiator hose.

Remove thermostat assembly (water inlet).

INSPECTION AFTER REMOVAL

  • Place a thread so that it is caught in the valves of the thermostat. Immerse fully in a container filled with water. Heat while stirring.

  • The valve opening temperature is the temperature at which the valve opens and the thermostat falls from the thread.

  • Continue heating. Check the full-open lift amount.

  • After checking the full-open lift amount, lower the water temperature and check the valve closing temperature.

    Thermostat Standard values
    Valve opening temperature Refer to Thermostat.
    Full-open lift amount Refer to Thermostat.
    Valve closing temperature Refer to Thermostat.
  • If thermostat values are out of standard range, replace water inlet and thermostat assembly.

INSTALLATION

Installation is in the reverse order of removal.

  • After installation, refill engine coolant and check for leaks. Refer to Changing Engine Coolant and System Inspection.

    • Do not spill engine coolant in engine compartment. Use a shop cloth to absorb engine coolant.