Renault Megane Quiz
Air conditioning

Power module

In this manual: Air conditioning
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~2min read

LEFT-HAND DRIVE

Tightening torques
battery cover screw 0.4 daN.m

The power module controls the fan motor speed according to the requirements determined by the control system.

It is accessed from underneath the dashboard.

Module de puissance

REMOVAL

  • Disconnect the battery, starting with the negative terminal.
  • Remove the trim panel at (1).
  • Disconnect the electrical connection (2).
  • Remove:
  • the accelerator pedal connector (3),
  • the two power module connectors (4),
  • the power module screw (5).
Module de puissance
  • Remove the power module (the power module is held by lugs).

INSTALLATION

  • Connect the power module connectors.
  • Refit in the reverse order of removal.
WARNING

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

  • Torque the battery cover screws (0.4 daN.m).

RIGHT-HAND DRIVE

Tightening torques
battery cover screw 0.4 daN.m

The power module controls the fan motor speed according to the requirements determined by the control system.

REMOVAL

  • Disconnect the battery, starting with the negative terminal.
  • Remove the front passenger-side sill trim (upper part).
Module de puissance
  • Remove the passenger-side dashboard side panel.
Module de puissance
  • Remove the screws (1).
Module de puissance
  • Unclip the clip (3) located behind the bonnet release lever bracket.
  • Disengage the duct (4).
  • Lift the duct (5).
  • Remove the air distribution duct.
Module de puissance
  • Remove:
  • the brake pedal switch located at (7),
  • the connector screws (6),
  • the two power module connectors (8),
  • the power module screw.
Module de puissance
  • Remove the power module (the power module is held by lugs).

INSTALLATION

Note:
  • The brake pedal switch has automatic adjustment that adapts to the pedal position.
  • Before refitting the switch, set it to its fully extended position by pulling on the plunger.
  • Position the switch in its housing and turn it a quarter turn clockwise.
Module de puissance
  • Reconnect the power module connectors.
  • Refit in the reverse order of removal.
  • Reshape the air duct by working through the air outlet holes and applying hand pressure perpendicular to the fold.
WARNING

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

  • Torque the battery cover screws (0.4 daN.m).

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.