Renault Megane Quiz
Air conditioning

Blend door motor

In this manual: Air conditioning
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~2min read

RIGHT-HAND DRIVE

Tightening torques
battery cover screw 0.4 daN.m

REMOVAL

Note: The blend door motor is located at the bottom left of the air conditioning unit.
  • Disconnect the battery, starting with the negative terminal.
Moteur de mixage
  • Remove:
  • the upper part of the front sill trim,
  • the passenger side dashboard side panel (1).
Moteur de mixage
  • Remove the storage tray mounting screws (2).
  • Remove:
  • the storage tray,
  • the trim panel (3).
Moteur de mixage
  • Disconnect the motor (4).
  • Remove the three motor mounting screws (4).
  • Remove the motor (4).

INSTALLATION

  • Refit in the reverse order of removal.
  • Turn the flap spindle with a suitable screwdriver to align the flap index with that of the motor.
WARNING

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

  • Torque the battery cover screws (0.4 daN.m).

LEFT-HAND DRIVE

Tightening torques
crossmember reinforcement plate mounting screws 2.1 daN.m
elastic mount mounting screws 0.2 daN.m
battery cover screw 0.4 daN.m

REMOVAL

  • Disconnect the battery, starting with the negative terminal.
Note: The blend door motor is located at the bottom left of the air conditioning unit.
Moteur de mixage
  • Remove the front sill trim (upper part).
  • Unclip:
  • the lower cover (1),
  • the dashboard side panel (2).
Moteur de mixage
  • Disconnect the headlight levelling control unit (3).
  • Remove:
  • the control unit,
  • the trim panel mounting screws (4),
  • the trim panel (9).
Moteur de mixage
  • Remove the trim panel (5).
Moteur de mixage
  • Release the plastic connecting stud (6) between the housing and the crossmember reinforcement plate.
  • Disconnect the heater resistors.
  • Unclip the harness from the crossmember reinforcement plate (7).
  • Remove the crossmember reinforcement plate.
Moteur de mixage
  • Disconnect the motor (8).
  • Remove:
  • the three motor mounting screws (8),
  • the motor (8).

INSTALLATION

  • Refit in the reverse order of removal.
  • Turn the flap spindle with a suitable screwdriver to align the flap index with that of the motor.
  • Tighten to the following torques:
  • the crossmember reinforcement plate mounting screws (2.1 daN.m),
  • the elastic mount mounting screws (0.2 daN.m).

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.