Air conditioning
Control panel
In this manual: Air conditioning
~1min read
Essential special tools |
|
| Ms. 1544 | Radio removal tool - Carminat Becker |
| Ms. 1373 | Philips radio removal tool |
| Ms. 1639 | Radio removal tool - CD changer |
| Car. 1597 | Trim clip removal lever for the rear cornering grab handle |
Tightening torques |
|
| air conditioning control panel mounting screw | 0.2 daN.m |
| battery cover screw | 0.4 daN.m |
REMOVAL

- Disconnect the battery, starting with the negative terminal.
- Remove:
- the centre console tray (if equipped),
- Carminat using tool (Ms. 1544) or (Ms. 1373) (if equipped),
- the CD changer using tool (Ms. 1639) (if equipped),
- the radio using tool (Ms. 1373) (if equipped).

- Disconnect the connectors.
- Remove:
- the lower centre facia at (1),
- the four screws (2) of the centre facia (3).
- Release the card reader holder using tool (Car. 1597).
- Disconnect the connectors from the centre facia (3).

- Remove the two control panel mounting screws (4).

- Pull out the heater control panel, tilting it towards the inside of the dashboard.
- Disconnect the control panel connectors.
INSTALLATION
- Refit in the reverse order of removal.
Connect the battery; carry out the necessary relearn procedures (Chapter Battery).
- Tighten to the following torques:
- air conditioning control panel mounting screw (0.2 daN.m),
- the battery cover bolts (0.4 daN.m).
Test yourself
A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?
