Rear wiper motor

REMOVAL

• Disconnect the battery.
• Remove the interior trim panels (see Tailgate Trim).

• Remove:

• the wiper arm nut,
• the wiper arm using tool (Ele. 1294-01) or tool (Ele. 1552).

• Remove:

• the arm cover (2),
• the sealing gasket (3),
• the two arm cover retaining clips from inside the box section (4).

• Disconnect the connector.
• Drill out the motor mounting rivets (1).

• Do not damage the outer skin of the tailgate with the drill bit.
• Remove the rivet bodies from inside the box section.

INSTALLATION

CAUTION Use the specific rivets, part number 77 03 072 362.

• Position and rivet the motor.
• Connect the connector.

• Check the condition of the clips (5).
• Replace the clips if necessary.
• Clip on the cover.
• Clean the splines of the motor shaft.
• Position the wiper arm in the park position with a new nut.
• Replace the sealing gasket every time the motor is removed.
• Reconnect the battery.

Make sure the wiper motor is correctly in the fixed park position.

• Refit the wiper arm.
• Tighten the wiper arm nut to torque (1.2 daN.m).

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).