Brake Pedal Repair Procedures

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Remove the lower driver airbag panel. (Refer to Body - "Driver Airbag Module")
3. 3
   Remove the knee airbag. (Refer to Restraint - "Knee Airbag (KAB) Module").
4. 4
   Disconnect the stop lamp switch connector (A), then remove the stop lamp switch.

   

5. 5
   Pull the steering column shaft down after removing the bolts and nuts. (Refer to Steering System - "Steering Column and Shaft")
6. 6
   Remove the brake pedal mounting nut (A).

   Tightening torque: 9.8 ~ 14.7 N·m

   

7. 7
   Remove the lock pin (A) and the flat head pin (B).

   

8. 8
   Remove the nuts securing the brake pedal assembly, then remove the brake pedal assembly.

   Tightening torque: 9.8 ~ 14.7 N·m

   

Inspection

1. 1
   Inspect the bushing for wear.
2. 2
   Inspect the brake pedal for bending or twisting.
3. 3
   Inspect the brake pedal return spring for damage.

Installation

1. 1
   Installation is the reverse of removal.
2. 2
   Adjust the brake pedal height and free play.
3. 3
   Check the brake pedal operation.