Brake Line Repair Procedures

Removal

1. 1
   Disconnect the brake fluid level switch connector and remove the reservoir cap.
2. 2
   Remove the brake fluid from the master cylinder reservoir using a syringe.
3. 3
   Remove the wheel and tire.
4. 4
   Disconnect the brake tube by loosening the tube flare nut (B).

   Tightening torque: 12.7 - 16.7 N·m

   Front

   

   Rear

   

5. 5
   Remove the brake hose clamp (A).
6. 6
   Disconnect the brake hose from the brake caliper by loosening the bolt (C).

   Tightening torque: 24.5 - 29 N·m

   [Front]

   

   [General]

   

   [EPB]

   

Inspection

1. 1
   Inspect the brake tubes for cracks, bends and corrosion.
2. 2
   Inspect the brake hoses for cracks, damage and fluid leaks.
3. 3
   Inspect the tube flare nuts for damage and fluid leaks.
4. 4
   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1
   Installation is the reverse of removal.

   

2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake Bleeding") (Refer to ABS - "ABS Bleeding") (Refer to ESP (Electronic Stability Program) System - "ESP Bleeding")
3. 3
   Inspect for spilled brake fluid.