Emergency Front Belt Fixing Device (EFD) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least 3 minutes before starting work.
2. 2
   Remove the front seat. (Refer to Body - "Front Seat Assembly")
3. 3
   Remove the rear seat. (Refer to Body - "Rear Seat Assembly")
4. 4
   Remove the front seat belt anchor (A).

   

   When replacing the retractor pretensioner, be sure to use the proper tools to remove the seat belt anchor connector (A).

   Tools Required Tool A: 3 mm hex screwdriver or drill, 56 mm length or longer. Tool B: 3 mm screwdriver or drill.

   

   1. Insert tool (A) vertically into hole (F). Then tilt it more than 10°, as shown in the illustration.

      When tilted 10°, tool (A) pushes and rotates the inner part (C).

   2. Insert and push tool (B) vertically into hole (E). The seat belt anchor connector (D) will then be disconnected.

      

      

5. 5
   Remove the door scuff plate. (Refer to Body - "Interior Trim")
6. 6
   Remove the center pillar trim. (Refer to Body - "Interior Trim")
7. 7
   Remove the floor carpet assembly. (Refer to Body - "Floor Carpet")
8. 8
   Disconnect the anchor pretensioner (A).
9. 9
   Loosen the mounting bolt (B) and remove the anchor pretensioner.

   

Installation

1. 1
   Installation is the reverse of removal.
2. 2
   Connect the battery negative (-) terminal.