Hyundai Sonata LF Quiz
Restraints

Seat Belt Pretensioner (BPT) Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
14steps
~84min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 14

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the door scuff plate. (Refer to Body - "Interior Trim")
  3. Remove the center pillar trim. (Refer to Body - "Interior Trim")
  4. Loosen the seat belt pretensioner mounting bolts (A) and remove the seat belt pretensioner.
  5. Disconnect the seat belt pretensioner connector (B).

Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least three minutes.
  3. Install the seat belt pretensioner with the bolts (A).
  4. Connect the seat belt pretensioner connector (B).

    Tightening torque: Bolt B: 39.2 ~ 54 N·m

  5. Install the center pillar trim. (Refer to Body - "Interior Trim")
  6. Install the door scuff plate. (Refer to Body - "Interior Trim")
  7. Insert the seat belt into the anchor pretensioner.
    Make sure the stopper pin is inserted correctly.
  8. Connect the negative battery cable.
  9. After installing the seat belt pretensioner, check the system operation:
    A. Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.