Rear Door Trim Repair Procedures

Replacement

Wear gloves to protect your hands.

When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage. Be careful not to scratch the door trim and other parts.

1. 1
   Using a screwdriver or remover, remove the rear door delta inner cover (A).

   

2. 2
   Using a flat-tip or a remover, remove the rear door cap (A).

   

3. 3
   Pull the front door inside handle with a flat-head screwdriver and remove the cover (A) using the opening located inside the handle.

   

4. 4
   After loosening the mounting screws, remove the rear door trim panel (A) using a flat-tip screwdriver.

   

5. 5
   Remove the rear door inside handle (A).
6. 6
   Disconnect the window regulator switch connector (B).

   

7. 7
   Remove the rear door quarter window assembly. (Refer to Rear Door - Rear Door Quarter Window Assembly)
8. 8
   Install in the reverse order of removal.

   Make sure the connector is properly connected. Check that the door locks/unlocks and opens/closes properly. Replace all damaged clips.