Rear Door Glass Repair Procedures

Replacement

1. 1
   Lower the rear door glass by pressing the power window switch.
2. 2
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
3. 3
   Remove the rear door weatherstrip from the outside (A).

   

4. 4
   After loosening the mounting screws, remove the rear door delta garnish (A).

   

   

5. 5
   Fully loosen the rear door channel mounting bolt and loosen the nuts as much as possible without removing the nuts from the rear door panel. Tightening torque: Bolt: 6.9 ~ 10.8 N·m Nut: 3.9 ~ 5.9 N·m
6. 6
   Lightly push the rear door channel in the direction shown by the arrow in the illustration below.

   

7. 7
   Remove the rear door glass mounting hole plug (A).

   

8. 8
   Carefully adjust the rear door glass (A) so that the bolt is visible, then loosen them. Separate the glass from the glass bracket and carefully pull the glass out through the window opening.

   Tightening torque: 7.8 ~ 11.8 N·m

   

   Be careful not to drop the glass and/or scratch its surface.

   Using the door switch, align the mounting hole/bolt with the hole in the door. If the window regulator motor does not operate, remove the motor and align the hole manually.

9. 9
   Install in the reverse order of removal.

   Move the glass up and down to check that it moves freely without binding. If necessary, adjust the glass position. Check that the door locks and opens properly. Replace all damaged clips.