Diagnostic Trouble Code Chart
NOTICE:
Turn the ignition switch off before removing parts.
HINT:
- If no abnormality is found when inspecting parts, inspect the stabilizer control ECU and ground points for poor contact.
- If a trouble code is output during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the "See page" for the respective "DTC Code" in the DTC chart.
- When 2 or more DTCs are output, perform circuit inspections one by one until the problem is identified.
- Inspect the fuse and relay before investigating the trouble areas as shown in the table below.
DTC Code | Detection Item | Trouble Area | See page |
|---|---|---|---|
C1812/12 |
Pressure Sensor Malfunction / Upside |
- Harness or connector - Accumulator pressure sensor (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
.gif) |
C1831/31 |
Accumulator Solenoid Malfunction / Upside |
- Harness or connector - Stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1832/32 |
Accumulator Solenoid Malfunction / Downside |
- Harness or connector - Stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1851/51 |
Low Pressure Malfunction in Upside of KDSS System |
- Hydraulic circuit - Harness or connector - Accumulator pressure sensor or stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1853/53 |
High Pressure Malfunction in Upside of KDSS System |
- Hydraulic circuit - Harness or connector - Accumulator pressure sensor or stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1879/79 |
Zero Point Calibration of Acceleration Sensor Undone |
- Brake control system (Yaw rate and acceleration sensor zero point calibration) - Stabilizer control ECU |
|
C1881/81 |
KDSS ECU Malfunction |
Stabilizer control ECU |
|
C1882/82 |
Power Supply Voltage Malfunction |
- Battery - Charging system - KDSS fuse - Harness or connector - Stabilizer control ECU |
|
C1883/83 |
Speed Sensor Circuit Malfunction |
- Brake control system - CAN communication system - Stabilizer control ECU |
|
C1884/84 |
Steering Angle Sensor Circuit Malfunction |
- Steering angle sensor (Spiral cable sub-assembly) - CAN communication system - Stabilizer control ECU |
|
C1887/87 |
Acceleration Sensor Circuit Malfunction |
- Yaw rate and acceleration sensor - CAN communication system - Stabilizer control ECU |
|
U0100/71 |
Lost Communication with ECM / PCM "A |
CAN communication system |
|
U0122/71 |
Lost Communication with Vehicle Dynamics Control Module |
CAN communication system |
|
U0124/71 |
Lost Communication with Lateral Acceleration Sensor Module |
CAN communication system |
|
U0126/71 |
Lost Communication with Steering Angle Sensor Module |
CAN communication system |
|
Test yourself
A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.