Toyota 4Runner Quiz
Vehicle Exterior

Inspection

In this manual: Vehicle Exterior
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
6steps
~36min
2/5difficulty
Done 0 of 6
INSPECTION PROCEDURE

1. INSPECT BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Check that the motor gear rotates smoothly as follows.

NOTICE:

Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

OK:

Measurement Condition

Specified Condition
  1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP).
  3. Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second.

Motor gear rotates clockwise (Up)
  1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN).
  3. Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second.

Motor gear rotates counterclockwise (Down)
  • If the result is not as specified, replace the front power window regulator motor assembly.

CAUTION:

Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.

Text in Illustration

*a

Motor Gear

*b

Clockwise

*c

Counterclockwise

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.