Installation

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NOTICE:

The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.

(a) Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws. HINT: Tighten the screws in the order shown in the illustration. A new power window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are installed. Torque: 5,4 N·m {55 kgf·cm, 48 in·lbf}

2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

6. INSTALL REAR DOOR GLASS RUN LH

7. INSTALL REAR DOOR SERVICE HOLE COVER LH

8. INSTALL REAR SPEAKER ASSEMBLY

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

11. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. INITIALIZE POWER WINDOW CONTROL SYSTEM

(a) Initialize the power window control system (See page ).