Rear Door Speaker

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

4. REMOVE REAR SPEAKER ASSEMBLY

(a) Disconnect the speaker connector.

(b) Remove the 3 screws.

(c) Detach the 2 claws and remove the speaker.

NOTICE:

Do not touch the cone of the speaker.

1. INSPECT REAR SPEAKER ASSEMBLY (for 8 Speakers)

(a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Always 4 Ω If the result is not as specified, replace the rear speaker assembly. Text in Illustration *a Component without harness connected (Rear Speaker Assembly)

2. INSPECT REAR SPEAKER ASSEMBLY (for 9 Speakers)

(a) Temporarily replace the rear speaker assembly with a new or normally functioning one.

OK:

Malfunction disappears.

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. INSTALL REAR SPEAKER ASSEMBLY

(a) Temporarily install the speaker by attaching the 2 claws of the speaker to the door panel.

(b) Install the speaker with the 3 screws.

Torque:

2,5 N·m {25 kgf·cm, 22 in·lbf}

NOTICE:

Do not touch the cone of the speaker.

(c) Connect the connector.

2. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH