Telephone and GPS Antenna Cables
Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during telephone and GPS antenna cable assembly removal/installation are shown below.
Procedures Required After Replacement / Removal / Installation of PartsReplaced Part or Performed Procedure | Required Procedure | Effect/Inoperative Function When Required Procedure Is Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here![]()
PROCEDURE
1. REMOVE TELEPHONE AND GPS ANTENNA CABLE ASSEMBLY
Click here![]()
Components
COMPONENTS
ILLUSTRATION
*1 |
TELEPHONE AND GPS ANTENNA CABLE ASSEMBLY |
*2 |
HEATER DAMPER DUCT SUB-ASSEMBLY NO. 3 |
ILLUSTRATION
*A |
for type A |
*B |
for type B |
*1 |
TELEPHONE AND GPS ANTENNA CABLE ASSEMBLY NO. 2 |
*2 |
TELEPHONE AND GPS ANTENNA CABLE ASSEMBLY NO. 3 |
*3 |
ADHESIVE TAPE |
- |
- |
![]() |
N*m (kgf*cm, lbf*in): Specified torque |
● |
Non-reusable part |
*T1 |
for type A: 10.5 N*m (107 kgf*cm, 8 ft*lbf) for type B: 10 N*m (102 kgf*cm, 7 ft*lbf) for type C: 10 N*m (102 kgf*cm, 7 ft*lbf) |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. REINSTALL TELEPHONE AND GPS ANTENNA CABLE ASSEMBLY
Click here![]()
.gif)
.png)