Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE GENERATOR PULLEY COVER
(a) Using a screwdriver, remove the Generator Pulley Cover from the Generator Pulley with Clutch. NOTICE: Do not reuse the Generator Pulley Cover. |
![]() |
2. REMOVE GENERATOR PULLEY WITH CLUTCH
(a) Secure the Generator Drive End Frame in a vise between aluminum plates.
(b) Confirm the SSTs (A) and (B) shown in the illustration. SST: 09820-63021 |
![]() |
(c) Place the end of the Rotor Shaft into the SST (A). |
|
(d) Place the SST (B) on the Generator Pulley with Clutch. |
|
(e) Loosen the Generator Pulley with Clutch by turning the SST (B), as shown in the illustration. NOTICE:
|
|
(f) Remove the SST from the Generator Pulley with Clutch.
(g) Remove the Generator Pulley with Clutch from the Rotor Shaft.
(h) Remove the Generator Assembly from the vise.
3. REMOVE GENERATOR REAR END COVER
(a) Place the Generator Assembly on the Generator Pulley with Clutch. |
![]() |
(b) Remove the 3 nuts and the Generator Rear End Cover from the Generator Stator Assembly. |
![]() |
4. REMOVE GENERATOR TERMINAL INSULATOR
(a) Remove the Generator Terminal Insulator from the Generator Stator Assembly. |
![]() |
5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and the Generator Brush Holder Assembly from the Generator Stator Assembly. |
![]() |
6. REMOVE GENERATOR STATOR ASSEMBLY
(a) Remove the 4 bolts. |
![]() |
(b) Using the SST, remove the Generator Stator Assembly. SST: 09950-40011 09951-04020 09952-04010 09953-04020 09954-04010 09955-04071 09957-04010 |
|
(c) Remove the Bearing Cover Seal. NOTICE: If the Bearing Cover Seal is broken, remove all broken pieces. HINT: The Bearing Cover Seal may be installed on the Generator Rotor Assembly. |
![]() |
7. REMOVE GENERATOR ROTOR ASSEMBLY
(a) Remove the generator rotor assembly from the generator drive end frame. |
|
8. INSPECT GENERATOR DRIVE END FRAME BEARING
Click here![]()
9. REMOVE GENERATOR DRIVE END FRAME BEARING
(a) Remove the 4 screws and the retainer plate from the generator drive end frame. |
![]() |
(b) Using the SST and a hammer, drive out the generator drive end frame bearing. SST: 09950-60010 09951-00250 SST: 09950-70010 09951-07100 |
![]() |














