Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during Generator Assembly removal/installation are indicated below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Required Procedure | Effect/Inoperative function when procedure not performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
PROCEDURE
1. PRECAUTIONS
NOTICE:
After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.
Click here
![]()
2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
3. REMOVE FAN AND GENERATOR V BELT
Click here![]()
4. REMOVE GENERATOR ASSEMBLY
(a) Remove the Generator Terminal Cap Assembly. |
![]() |
(b) Remove the nut and disconnect the cable from terminal B.
(c) Disconnect the Generator Assembly connector.
(d) Release the clip to disconnect the wire harness from the wire harness clamp bracket.
(e) Remove the 2 bolts and the Generator Assembly. |
![]() |
(f) Remove the bolt and the wire harness clamp bracket from the Generator Assembly. |
![]() |
.gif)


