3zr-fae Battery / Charging

Inspection

~3min read

INSPECTION

PROCEDURE

1. INSPECT GENERATOR PULLEY WITH CLUTCH

(a) Hold the center of the generator pulley with clutch, and check that the outer race turns counterclockwise and not clockwise.

OK:

The outer race turns counterclockwise and not clockwise.

If the result is not as specified, replace the generator pulley with clutch.

*a

Release

*b

Lock

2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

(a) Using vernier calipers, measure the exposed length of the brushes.

Standard Exposed Brush Length:

9.5 to 11.5 mm (0.374 to 0.453 in.)

Minimum Exposed Brush Length:

4.5 mm (0.177 in.)

If the brush length is less than the minimum, replace the generator brush holder assembly.

*a

Length

3. INSPECT GENERATOR ROTOR ASSEMBLY

(a) Check for an open circuit in the generator rotor assembly.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

Slip Ring - Slip Ring

20 °C

2,3 à 2,7 Ω

If the result is not as specified, replace the generator rotor assembly.

*a

Slip Ring

(b) Check for a short circuit to ground in the generator rotor assembly.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

Slip Ring - Rotor

Always

10 MΩ minimum

If the result is not as specified, replace the generator rotor assembly.

*a

Slip Ring

*b

Rotor

(c) Check that the generator rotor bearing is not rough or worn and turns freely.

If the generator rotor bearing is rough, worn, or does not turn freely, replace the generator rotor assembly.

(d) Inspect the slip ring.

(1) Check that the slip rings are free of roughness and scratches.

If the slip rings are rough or scratched, replace the generator rotor assembly.

(2) Using vernier calipers, measure the diameter of the slip ring.

Standard Diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)

Minimum Diameter:

14.0 mm (0.551 in.)

If the diameter is less than the minimum, replace the generator rotor assembly.

*a

Diameter

4. INSPECT GENERATOR DRIVE END FRAME BEARING

(a) Check that the generator drive end frame bearing is not rough or worn and turns freely.

If the generator drive end frame bearing is rough, worn, or does not turn freely, replace the generator drive end frame bearing.