Exterior Panels / Trim

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the rear door belt moulding are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

  • Rear Door Window Regulator Assembly
  • Rear Door Window Glass Subassembly
  • Rear Door Window Slider

Initialize Power Window Control System

  • Automatic Open and Close Function
  • Anti-Pinch Function
  • Anti-Pinch Function Operation
  • Remote Control Function
  • Key-Linked Function
  • Function Linked to Remote Control Transmitter
  • Keyless Operation
  • Power Window Open Warning Function

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. PRECAUTIONS

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE THE REAR DOOR INSIDE HANDLE GARNISH CLIP

Click here

4. REMOVE THE REAR POWER WINDOW SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Click here

5. REMOVE THE REAR DOOR REAR FRAME BRACKET

Click here

6. REMOVE THE REAR DOOR TRIM PANEL SUB-ASSEMBLY

Click here

7. REMOVE THE REAR DOOR BELT REAR WEATHERSTRIP

Click here

8. REMOVE THE REAR DOOR GLASS INNER WEATHERSTRIP

Click here

9. REMOVE THE REAR DOOR BELT WEATHERSTRIP

Click here

10. DETACH THE REAR DOOR WIRE

(a) Disconnect the rear door wire until the screw of the rear door glass lower frame sub-assembly is visible.

11. REMOVE THE REAR DOOR SERVICE HOLE COVER

Click here

12. REMOVE THE REAR DOOR GLASS LOWER REAR FRAME SUB-ASSEMBLY

Click here

13. REMOVE THE REAR DOOR GLASS SUB-ASSEMBLY

Click here

14. REMOVE THE REAR DOOR FRAME GARNISH

Click here

15. REMOVE THE REAR DOOR GLASS RUN

Click here

16. REMOVE THE REAR DOOR QUARTER GLASS

Click here

17. REMOVE THE REAR DOOR BELT MOULDING ASSEMBLY

(a) Apply protective tape around the rear door belt moulding assembly.

Protective tape

(b) Release the claws to remove the rear door belt moulding assembly, as shown in the illustration.

Remove in this direction