Exterior Panels / Trim

Wheel Opening Moulding (for Front)

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

FRONT FENDER MOULDING SUBASSEMBLY

-

-

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. INSTALL FRONT FENDER MOULDING SUBASSEMBLY

(a) Install the pin retaining clip as shown in the illustration.

Install in this direction

NOTICE:

Insert the pin retaining clip using the vertically aligned groove.

Do not rotate the clip after inserting it.

After installation, make sure the groove is aligned vertically.

HINT:

Repeat the same procedure for the right side and the left side.

(b) Engage the claws and clips to install the front fender moulding subassembly, as shown in the illustration.

Install in this direction

(c) Install the 3 clips and 5 screws.

(d) Remove the protective tape.

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. REMOVE FRONT FENDER MOULDING SUBASSEMBLY

(a) Remove the 3 clips and 5 screws.

(b) Apply protective tape around the front fender moulding subassembly.

Protective tape

(c) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin retaining clips.

HINT:

Repeat the same procedure for the right side and the left side.

*1

Pin Retaining Clip

*a

90 deg.

(d) Pull the rear edge of the front fender liner and release the claws by pushing the area indicated by the arrow in the illustration with your finger.

Place hands here

Remove in this direction (1)

Remove in this direction (2)

NOTICE:

  • Do not pull the front fender liner rearward with excessive force.
  • To avoid damaging the claws, do not pull the front fender moulding sub-assembly with excessive force.

(e) Release the clips to remove the front fender moulding sub-assembly, as shown in the illustration.

Place hands here

Remove in this direction