Exterior Panels / Trim

Rocker Panel Moulding

~3min read

Components

COMPONENTS

ILLUSTRATION

*1

REAR WHEEL ARCH FRONT PLATE

*2

ROCKER PANEL MOULDING

●

Non-reusable part

-

-

ILLUSTRATION

*1

ROCKER PANEL MOULDING CUSHION

-

-

●

Non-reusable part

-

-

Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL THE ROCKER PANEL MOULDING CUSHION

HINT:

  • Repeat the same procedure to remove each rocker panel moulding cushion.
  • When installing the rocker panel moulding cushion, heat the rocker panel moulding using a heat lamp.

Heating temperature:

Item

Temperature

Rocker Panel Moulding

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.

    *a

    Hot Surface

    *b

    Heat Lamp

  • Prolonged contact with heated parts may cause burns.

NOTICE:

Do not overheat the rocker panel moulding.

(a) Clean the radiator grille seal surface.

(1) Using a heat lamp, heat the radiator grille seal surface.

(2) Remove the double-sided adhesive tape from the rocker panel moulding.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat lamp, heat the rocker panel moulding.

(c) Remove the protective sheet from a new rocker panel moulding cushion.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the rocker panel moulding cushions.

HINT:

Attach a rocker panel moulding cushion along the radiator grille seal line.

*a

Line

Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE ROCKER PANEL MOULDING CUSHION

HINT:

Repeat the same procedure to remove each rocker panel moulding cushion.

(a) Remove the rocker panel moulding cushion.

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL ROCKER PANEL MOULDING

(a) Engage the clips to install the rocker panel moulding, as shown in the illustration.

Install in this direction (1)

Install in this direction (2)

(b) Engage the claw to connect the left quarter outside moulding, as shown in the illustration.

Install in this direction

(c) Install the 5 screws.

(d) Install the 8 new clips.

(e) Remove the protective tape.

2. INSTALL REAR WHEEL OPENING PLATE

Click here