Parking Brake

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. PRECAUTIONS

Click here

2. RELEASE PARKING BRAKE

(a) Place the shift lever in P.

(b) Turn the ignition switch to ON.

(c) Operate the electric parking brake switch assembly to release the parking brake.

HINT:

If the parking brake cannot be released:

  • TMC production:

    Click here

  • TMMT production:

    Click here

(d) Turn the ignition switch to OFF.

3. REMOVE REAR WHEEL

Click here

4. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Disconnect the No. 2 parking brake cable assembly connector from the parking brake actuator assembly.

NOTICE:

  • Remove all dirt or foreign matter on and around the No. 2 parking brake cable assembly connector before performing this operation.
  • Be careful not to let water, oil or dirt get into the No. 2 parking brake cable assembly connector.

5. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY

(a) Using a 5 mm hexagon socket wrench, remove the 2 bolts and the parking brake actuator assembly from the rear disc brake cylinder assembly.

NOTICE:

  • Check that there is no brake fluid leakage from the rear of the rear disc brake cylinder assembly.
  • If there is brake fluid leakage, replace the rear disc brake cylinder assembly.

(b) Remove the O-ring from the rear disc brake cylinder assembly.