Parking Brake

Installation

~1min read
010203040508.46N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

(a) Apply a thin coat of lithium soap based glycol grease to a new O-ring.

(b) Install the O-ring to the rear disc brake cylinder assembly.

NOTICE:

Be sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

(c) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

Torque:

Manufactured by TMC:

8.4 N·m {86 kgf·cm, 74 in·lbf}

Manufactured by TMMT:

11 N·m {112 kgf·cm, 8 ft·lbf}

2. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the No. 2 parking brake cable assembly connector to the parking brake actuator assembly.

3. INSTALL REAR WHEEL

Click here